AIM - rcparkflyers
Great Planes Yak 55 3D FlightFlex EP ARF Part 5
Final setups
Well the end is here... Yippie.
First I installed the servos for the tail assembly. They went pretty much without a hitch. I did mount them vertically as opposed to horizontal. I asked a few of the more experienced builders if this would be a problem with the performance of the servo. Most servos that I have installed are longways pointed to the moving part and I was wondering if by installing them the short way would have a different torque and degredation of performance. They looked over the model and said "nope" so I went with it.
Next I installed the motor. I used a Himax inrunner, a 4266.
I then mated it up with a Castle Creations 35 amp speed controller.
I made sure I put a few twists in the wires to hopefully knock down the RF interference.
Lastly I installed a Hitec 555 receiver
Next post will detail the flight tests and thoughts on the aircraft.
Pix follow
Elevator
Click to Enlarge
Rudder
Click to Enlarge
Motor
Click to Enlarge
Cockpit
Click to Enlarge
Written By: jacq on Friday, September 08, 2006
PermaLink | 0 comments | Click to Comment
Bookmark at: 
0 Comments:
Post a Comment
<< Home