AIM - rcparkflyers
Great Planes Yak 55 3D FlightFlex EP ARF Part 1
Main Wing - Horizontal Stab
Got the main wing glued in. I used foam safe CA from BSI. And I got it here at LONE STAR MODELS on the recommendation of BSI as I could not find all their adhesives locally anymore. Had to put quite a bit of glue around fuse and wing. Both did not quite fit snug.
I measured the leading edge of wing on each side to verify that it was in the middle and did a rough nose measurement for squareness
Installing the horizontal stab went ok. I had to make sure per the instructions that it was square with the fuse. So I took a string and tied it around the engine stick mount and verified it was close. I then took a long ruler from a T-square and did a more accurate measurement. Seemed ok.
Did a quick pix nose on view to get somewhat an idea of finished product... Josef decided to make an appearance. Future builder and pilot.
Pix follow
Main Wing side view
Click to Enlarge
Horizontal Stab an Fuse
Click to Enlarge
Horizontal Stab installed
Click to Enlarge
Main Wing Nose view -- Josef my son looking on
Click to Enlarge
Written By: jacq on Thursday, April 27, 2006
PermaLink | 1 comments | Click to Comment
Bookmark at: 
1 Comments:
That last picture is good - I thought it was more of a flat plane, but you can see in that picture that its more sturdy.
-Will
By Will, at Sun Apr 30, 07:59:54 PM 2006
Post a Comment
<< Home